["2016-Honda-Civic 1.5T Non Si-Coupe","2016-Honda-Civic 1.5T Non Si-Hatchback","2016-Honda-Civic 1.5T Non Si-Sedan","2017-Honda-Civic 1.5T Non Si-Coupe","2017-Honda-Civic 1.5T Non Si-Hatchback","2017-Honda-Civic 1.5T Non Si-Sedan","2017-Honda-Civic 1.5T Si-Coupe","2017-Honda-Civic 1.5T Si-Sedan","2018-Honda-Civic 1.5T Non Si-Coupe","2018-Honda-Civic 1.5T Non Si-Hatchback","2018-Honda-Civic 1.5T Non Si-Sedan","2018-Honda-Civic 1.5T Si-Coupe","2018-Honda-Civic 1.5T Si-Sedan","2019-Honda-Civic 1.5T Non Si-Coupe","2019-Honda-Civic 1.5T Non Si-Hatchback","2019-Honda-Civic 1.5T Non Si-Sedan","2019-Honda-Civic 1.5T Si-Coupe","2019-Honda-Civic 1.5T Si-Sedan","2020-Honda-Civic 1.5T Non Si-Coupe","2020-Honda-Civic 1.5T Non Si-Hatchback","2020-Honda-Civic 1.5T Non Si-Sedan","2020-Honda-Civic 1.5T Si-Coupe","2020-Honda-Civic 1.5T Si-Sedan","spo-enabled"]
Turbocharger Inlet Pipe Kit for 2016-2021 Honda Civic 1.5T
Adding product to your cart
PRE-ORDERS LIVE 07/08/2021 AT NOON EST, ORDERS CAPPED AT 500
09/01/2021 EXPECTED SHIP DATE
FITS ALL 2016-2021 HONDA CIVIC 1.5L TURBO MODELS INCLUDING SI & NON-SI, RHD, INTERNATIONAL MODELS, ETC
FITS FACTORY AND FACTORY REPLACEMENT TURBOCHARGER UPGRADES
PAIR WITH OUR RACE MAF HOUSING INTAKE SYSTEMS FOR OPTIMAL PERFORMANCE
ONLY COMPATIBLE WITH PRL MOTORSPORTS COBRA COLD AIR INTAKE SYSTEM OR PRL MOTORSPORTS SHORT RAM INTAKE SYSTEM
The PRL Motorsports Titanium Turbocharger Inlet Pipe Kit for the L15B7 is a direct bolt-on upgrade that eliminates airflow restriction before the turbocharger, allowing the turbocharger to operate more efficiently. Thin-wall Titanium keeps helps reduce heat-soak. Our design utilizes a cast aluminum inlet piece to allow smooth transition from the gasket-matched50mm ID compressor inlet to a76.2mm OD / 74mm ID outlet throughout the Titanium crossover pipe. The compressor outlet diameter is increased to 45mm from the factory's 38mm diameter. This kit was designed to compliment Honda's 1.5L displacement perfectly by providinga significant increase in airflow volume in comparison to the factory inlet pipe, while maintaining velocity. A multi-piece design allows for easier installation and better fitmentthan a one-piece design.
(1) Cast Aluminum Inlet Piece
(1) 76mm OD Titanium Inlet Pipe
(2) High-Temp 4-Ply Silicone Couplers
(5) 304 Stainless Steel Interlocking Worm Clamps
(4) Vacuum Hoses
(1) Injection Molded Evap Purge Fitting
(2) Buna O-Rings
(1) Wiring Harness Tie-Down
Use left/right arrows to navigate the slideshow or swipe left/right if using a mobile device
Choosing a selection results in a full page refresh.
Press the space key then arrow keys to make a selection.